HomeMatic HM-Sec-RHS Montageanleitung Und Bedienungsanleitung Seite 20

Note: If the sensor is already taught for a cen-
ter and therefore is blocked for direct training, it
can still be put in teach mode as described above but
no teaching occurs and the device LED is illuminated
in red.
Green LED
Red LED
Orange flashing
Brief orange flashing
and red or green
(depending upon
success)
8 Feedback by the device LED
The feedback signals apply for operation with and
without the center.
No actuators have been taught yet:
Status change: LED is briefly illuminated
38
Teaching successful
Teaching failed
Sensor in teach mode
Other device in teach
mode and sensor put in
teach mode.
Actuators are taught:
Status change: LED is illuminated in orange as long
as the function transfer requires, this time depends on
the number of actuators that have been taught for this
button, the number of required transmission attempts
and the encoding and transmission mode. After the
radio transmission is complete, the LED is illuminated
in either red or green for one second.
Green: all actuators have confirmed the (last) bi-
directional command,
Red: at least one actuator has confirmed the (last)
bi-directional command.
Sensor in special mode:
LED flashes slowly in orange: Teach mode (waiting for
radio signal or parameter definition),
LED flashes slowly in red: Preparatory stage for reset-
ting to factory defaults (waiting for long button press
on the teach button for resetting, or brief button press
for ending).
LED flashes quickly in red: Sensor is reset to factory
status.
39