Teaching - HomeMatic HM-Sec-RHS Montageanleitung Und Bedienungsanleitung

If the battery power is low, as long as the power
level allows, the sensor is activated and is ready for
operation. Depending on the requirements, the battery
may recover and send again many times after a short
break. If the power drops too low when sending, the
respective error code is displayed again.

7.2 Teaching

Please read this section completely before starting
with any teaching!
The two devices to be connected are set to teach
mode for teaching.
The teach button is located on the front of the device
under the battery compartment cover. This button is
located within a recess so that it cannot be pressed
accidentally.
36
To actuate teach mode on the window rotary handle
sensor, press the teach button with a pointed object.
The device LED flashes orange. (Abort with a short
press of the teach button, the device LED will then
illuminate in red.)
If no teaching occurs, teach mode is automatically
ended after 20 seconds. If other devices are in teach
mode, these are taught.
If learning is completed successfully, it is indicated with
the flashing green LED (length of time depends on
whether it is still configuring).
37