Pando E200/110 Bedienungsanleitung Mit Montageanweisungen Seite 18

If the rating lable in the cooker-hood shows
the symbol , the appliance is built in class
II° and it does not need any earth connection.
If the rating lable in the cooker-hood does
not show the symbol
in class I° and it needs the earth connection.
When performing the electrical connections
on the appliance, please make sure that the
current-tap is provided with earth connection
and that voltage values correspond to those
indicated on the label placed inside the ap-
pliance itself.
Before carrying out any cleaning or maintain-
ing operations, the appliance needs to be re-
moved from the electric grid.
If the appliance is not provided with a non-
separable flexible cable and plug, or with an-
other device ensuring omnipolar disconnec-
tions from the grid, with an opening distance
between the contacts of at least 3 mm, then
such disconnecting devices must be supplied
within the fixed installation.
If the appliance is endowed with a supply cord
and a plug, the appliance has to be put in a
place where the plug can be reached easily.
The use of materials which can burst into
flames should be avoided in close proxim-
ity of the appliance. When frying, please
pay particular attention to fire risk due
to oil grease. Being highly inflammable,
fried oil is especially dangerous. Do not
use uncovered electric grills. In order to
avoid possible fire risk, all instructions for
grease-filter cleaning and for removing
eventual grease deposits should be strictly
followed.
, the appliance is built
E200/150, E200/110,
E210/110 V1350, E205/110 V1100, E280/90
y E290/90 V1350 (External Motor) models
can be used only if connected with external
motors manufactured by the same producer.
E210/150 V1350, E210/110 V1350 and
E290/90 V1350 models are equipped with
internal motor.
PANELS OPENING
In E200/150, E200/110, E205/110 V1100,
E280/90, E210/150 V1350, E210/110 V1100
and E290/90 V1350 EM models it is possi-
ble to open the steel panels, which cover the
grease filters, by slightly pulling on a side of
the panel itself, as shown in Fig. 3.
To achieve the complete opening of panels,
you need to release the safety chains, by us-
ing the appropriate spring catches.
For correct functioning, it is recommended to
install the product at a maximum distance of
2500 mm from the floor.
Before starting the appliance installation,
please check that all components are not
damaged, in such a case contact your retailer
and do not carry out installation.
Furthermore, please read carefully all of
the following installation instructions.
- Use an exhausting pipe whose maximum
length does not exceed 5 meters.
- Limit the number of curves in the duct. Each
curve reduces the efficiency of the extraction.
Refer to the recommended duct installation in
the motor technical specifications.
- Avoid abrupt direction changes.
- Use a constant diameter pipe for the whole
length.
- Utilise ducting in material approved in ac-
cordance with the norms in force. For advice
about the motor version, refer to the table of
motor technical specifications.
- ATTENTION! The light bulbs in the E200/210
and 205 models have been removed to avoid
damaging them during transportation or in-
stallation. The bulbs are positioned inside the
hood; open the panel and remove the filter to
find them.
18
USES
E210/150 V1350,