JAC PaniForm Bedienungsanleitung Seite 8

10 MALFUNCTIONS
NB: The machine must be isolated from the power supply before attempting any work on it.
Problem
Open the lid immediately so that the dough is not left fermenting in
the tank. (If the handle is difficult to open by hand, refer to Problem 7).
Problem 1: The machine will not
Check the main power supply and the power supply to the motor.
start
Check whether the thermal cut-out has tripped.
Problem 2: The hydraulic power
pack starts up but the heads will Switch two phases on the machine plug.
not rise
Problem 3: Machine lacks power Check oil level. The level must be between 4 and 5 cm from the top edge.
Problem 4: The heads rise but the
Contact your technician.
knives do not extend
Problem 5: Oil on the floor Contact your technician.
Press the green button (fig. 3, n°21).
Problem 6: The green button Open the lid (if the handle is difficult to open by hand, refer to Problem 7).
flashes rapidly If the green button continues to flash rapidly, activate the emergency stop
and refer to Problem 8.
Do not try to force the lid open. Only one person should handle the
machine.
Problem 7: The lid cannot be Do not use a tool to force the lid open.
opened, or
If dough has fermented in the tank for more than a few minutes, be careful
The dough has been left when trying to open the lid. Keep away from the line of opening of the lid.
unsupervised in the closed tank
If the lid cannot be opened in accordance with the user instructions, please
contact your technician. Keep away from the line of opening of the lid until
the technician arrives.
1. If the lid is open:
Twist the mushroom button (emergency stop) (fig.3, n°16) ¼ turn to the
right.
Press the green button (fig. 3, n°21) to reset the machine.
2. If the lid is closed:
Problem 8: The emergency stop
Twist the mushroom button (emergency stop) (fig.3, n°16) ¼ turn to the
button has been pressed
right.
Press the green button (fig.3, n°21).
Open the lid (if the handle is difficult to open by hand, refer to Problem
7).
Press the green button (fig. 3, n°21) to reset the machine.
Problem 9: In the event of a power Open the lid immediately so that the dough is not left fermenting in
cut the tank. (If the handle is difficult to open by hand, refer to Problem 7).
Should the problem persist, please contact your technician.
Check
15
English
11 LIST OF COMPONENTS IN ILLUSTRATIONS
Figure
Item Description
1 Lid
2 Lid seal
3 Easyflour flour dispenser
4 Tank
5 Heads
6 Flour recovery
7 Easyflour flour dispenser guide rail
1
8 Braked castors
9 Lid closing handle
10 Lid closing eccentric
11 Easylock grid mount closing system
12 Grid frame
13 Door handle
14 Pressure setting compartment
2
15 Knives
16 Emergency stop
17 Pressure time
18 Knife cleaning
3
19 Half tank/full tank
20 10/20 selection button (10/20 option)
21 Green button and condition indicator
4
22 Work area
23 Flour recovery bin
7
24 Pressure setting
25 Easyflour flour dispenser filling area
12
26 Easyflour flour dispenser flow rate setting cursor
27 Pictogram indicating an electrocution hazard
14 28 Circuit diagram
29 Pictogram indicating a crushing hazard
English
16