Makita DTM40 Betriebsanleitung Seite 10

Vibration
The vibration total value (tri-axial vector sum) determined
according to EN62841-2-4:
Work mode: Sanding
Model DTM50
Vibration emission (a
Uncertainty (K): 1.5 m/s
The vibration total value (tri-axial vector sum) determined
according to EN62841-1:
Work mode: Cutting with plunge cut saw blade
Model DTM50
Vibration emission (a
Uncertainty (K): 1.5 m/s
The vibration total value (tri-axial vector sum) determined
according to EN62841-1:
Work mode: Cutting with segmential saw blade
Model DTM50
Vibration emission (a
Uncertainty (K): 1.5 m/s
The vibration total value (tri-axial vector sum) determined
according to EN62841-1:
Work mode: Scraping
Model DTM50
Vibration emission (a
Uncertainty (K): 1.5 m/s
NOTE:
• The declared vibration total value(s) has been mea-
sured in accordance with a standard test method and
may be used for comparing one tool with another.
• The declared vibration total value(s) may also be used
in a preliminary assessment of exposure.
WARNING:
• The vibration emission during actual use of the
power tool can differ from the declared value(s)
depending on the ways in which the tool is used
especially what kind of workpiece is processed.
• Be sure to identify safety measures to protect the
operator that are based on an estimation of expo-
sure in the actual conditions of use (taking account
of all parts of the operating cycle such as the times
when the tool is switched off and when it is running
idle in addition to the trigger time).
DECLARATIONS OF CONFORMITY
For European countries only
The Declarations of conformity are included in Annex A
to this instruction manual.
10
ENG900-1
2
or less
): 2.5 m/s
h
2
2
): 10.0 m/s
h
2
2
): 5.5 m/s
h
2
2
): 9.5 m/s
h
2
ENG901-2