Werbung
Verfügbare Sprachen
Verfügbare Sprachen
D16-P
e
STATEMENT OF USE
OPERATING
CYLINDER ORIENTATION
This tool is designed for only right hand rotation tapping of holes in
1. Torque reaction handles are recommended - the tool may be
metal and plastics,
mounted on a toolstand.
The cylinder must be correctly orientated so
Tap removal is by pulling the tool away from the workpiece, so
2.
The tools are fitted with a progressive throttle action. This allows
that all cut-outs in the cylinder and the
engaging reverse at twice forward speed.
for a low speed with a small throttle opening, ideal when
bearing plates co-incide.
commencing an operation.
GENERAL
i
3.
To reverse rotation quickly, whilst the motor is running, pull the
Recommended inlet hose
N
N
bo
toolaway from the workpiece briskly. It is unnecessary to cut
the power to the motor before reversing.
`
Trials are recommended
before commencing work.
ge 10mm
4. Take precautions to avoid stalling the tool in tapered holes and
$5
swarf jamming in blind holes.
5.
Use a depth gauge or indicator,
3m
6.
Use the correct pilot size.
7.
Always use a sharp cutting tool at the correct speed,
Lubrication
8. Do not reduce air supply.
Correct lubrication is vital for the maximum performance of the tool
MAINTENANCE
INSTRUCTIONS
—
0.3
ENDCAPTOBE
and an airline lubricator should be fitted in the system down line of
1.
Service should be carried out at intervals of 1000 hours' use.
0.2
PRESSED INTO BEARING
the filter. Use ISO VG 15 in lubricator set to provide 50 drops per
2.
All torque figures x 10%.
N
HOUSING IN DIRECTION
minute.
3.
Replace as necessary all 'O' rings, bearings and rotor blades.
OF ARROW 'A TO
158733
= Molycote PG75
273283 = BP FGOOEP
See service kits.
73283
DIMENSION SHOWN.
a
= reg
27662 = ISO VG 16
4. When disposing of components, lubricants, etc ... ensure that
i
=
the relevant safety procedures are carried out.
NET
SS
x
q
ah
"
i
TPD»,
DATA
—
5, €) Indicates direction of dismantling.
BEÐ
YW
7
Maximum air pressure Pmax
= 6.3 bar
6.
Torque values stated are for assembly.
EL
LL
ce
Minimum air pressure Pmin
= 2.0 bar
i
N
Sound Pressure Level (dBA)
=78 +2 re, CAGI-PNEUROP
Test code
i
THIS DIMENSION
Vibration Range (m/sec?)
= < 2.5 re. ISO 8662
TO APPLY AFTER
Weight
BEARING IS
016 -P- 750
= 1.7 kg
er
D16 - P- 450
= 1,8 kg
Accessories
A wide range of accessories are available and a suitable item
should be selected from the relevant Desoutter Catalogue.
BEFORE OPERATING THIS TOOL, READ AND
UNDERSTAND PNEUMATIC TAPPER SAFETY
INSTRUCTIONS PART NO. 354343
©Copyright 1995, Desoutter, London NW9 6ND, UK.
All rights reserved, Any unauthorized use or copying of the contents
or part thereof is prohibited. This applies in particular to trademarks,
model denominations, part numbers and drawings.
Use only authorized parts. Any damage or malfunction caused
by the use of unauthorized parts is not covered by Warranty or
Product Liability.
TM
Desouller
Desoutter Limited
me
Printed in England
3 of 14
Part No. 380183 Issue 1 7. 95
Werbung
