Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Risk of injury caused by falling objects
Devices in overhead installations may cause severe injuries when crashing down. Make sure that the
device is installed securely and cannot fall down. The installation must be carried out by a specialist
who is familiar with the hazards and the relevant regulations. The commissioning, operation and
maintenance of this product may only be carried out by qualified personnel.
Damage caused by laser radiation
Observe the warnings on page 17 when installing the device.
Safety bond
Fixation screw
This product is designed for overhead rigging only. Mount it to a wall or ceiling with the mounting bracket. If
necessary, it can also be fastened to a truss using appropriate clamps. To align the unit, release the fixation
screws at the mounting bracket, adjust the desired inclination angle and retighten the fixation screws. Make sure
not to point the laser beams at highly reflective surfaces such as mirror balls, windows and shiny objects. As a
precaution, remove or cover up highly reflective objects in order to avoid laser reflections.
Notes
• The device must be mounted out of normal reach.
• During installation and service work, the area below the installation location must be blocked.
• The installation of the device has to be built and constructed in a way that it can hold 10 times the weight for
1 hour without any harming deformation.
• The device must be additionally secured with e.g. an appropriate safety bond. Fasten the safety bond in such a
way that, in the event of a fall, the maximum drop distance of the device will not exceed 20 cm. This secondary
safety attachment must be constructed in a way that no part of the installation can fall down if the main
attachment fails.
• You must only use safety bonds and quick links complying complying with DIN 56927, shackles complying with
DIN EN 1677-1 and BGV C1 carbines. The safety bonds, quick links, shackles and the carbines must be
sufficiently dimensioned and used correctly in accordance with the latest industrial safety regulations (e. g. BGV
C1, BGI 810-3).
• Before using the device for the first time and after any significant modifications, the installation must be
inspected and approved by an expert.
INSTALLATION
WARNING!
DANGER!
20 • EN
Truss mounting clamp
Mounting bracket
Werbung
Kapitel
Inhaltsverzeichnis
