Stinger HEIGH10 Installationsanleitung Seite 7

3
Display Assembly
The display can be installed Flat or with a Horizontal Angle towards the driver. For flat mounting,
attach the Clamp Assembly (1) to the display using M4 X 14 screws (FIG. A). If a horizontal angle
is desired, insert the Angle Plate (2) in between the clamp and display and replace 2 of the M4 X
14 screws with longer M4 X 18 screws on the thicker side of the angle plate (FIG. B). Center the
bracket on the back of the display as a starting point, and if needed you can adjust up or down.
No Horizontal Angle
Always ensure TOP indicator on the Clamp Assembly is facing UP .
Multiple Mounting Options
HEIGH10 can be configured for different mounting applications:
4A
Using a Double DIN Dash Kit (PAGE 8)
4B
Using a Double DIN Sub-Dash Kit (PAGE 10)
4C
Using a Double DIN Factory Radio Mounting Brackets (PAGE 12)
4D
Using a Single DIN ISO Mountable Dash Kit, relocating Radio Module (PAGE 14)
See Stinger website for TECH TIPS on vehicle specific installations.
FIG. A
TOP
M4 X 12 (4X)
1
With Horizontal Angle
FIG. B
TOP
2
1
M4 X 14 (2X)
M4 X 18 (2X)
7