Stinger HEIGH10 Installationsanleitung Seite 16

5
Final Assembly
If needed, attach the rubber boot to
the display clamp assembly by aligning
the notch on the top edge as shown,
and hook the boot to the clamp at 5
locations. (FIG. W)
Note: The boot is not required if display
sits very close to the dash/dash kit and
BOOT ASSEMBLY PLASTIC "TAB"
no large gap is seen.
HAS TO GO INTO A NOTCH
(DISPLAY UNIT NOT SHOWN)
6
After all wiring connections are made
in the next section, the dash kit with the
radio chassis and bracket assembly,
should be installed and any factory
panels reinstalled. Connect the 8 Pin
Display Power Harness and the LVDS
Video Cable to the back of the display
and attach display to mounting bracket.
16
BOOT ASSEMBLY PLASTIC "TAB"
HAS TO GO INTO A NOTCH
(DISPLAY UNIT NOT SHOWN)
FIG. W
BOOT ASSEMBLY HOOKS
AT 5 SPOTS
(RUBBER BOOT NOT SHOWN)