Stinger HEIGH10 Installationsanleitung Seite 12

Using Factory Radio Brackets:
4C
Radio chassis mounts to the factory brackets in the sub-dash
Display Adjustment & Mounting:
1. Use all 8 kit mounting screws to attach the radio module & plastic mounting bracket assembly to the
factory brackets. (FIG. M)
a. (4x) #10 X 3/8 screws for the bottom locations.
b. (4x) M5 X 10 or (4x) M4 X 10 screws for the top locations (radio module).
If factory bracket is thinner than 1mm, add a washer to space the screws out.
New holes in the factory brackets may need
to be drilled for optimal screen position.
Note: There are multiple mounting holes on the
plastic mounting bracket to allow adjusting the
mounting depth. You may drill additional holes in
the mounting bracket and/or the factory brackets
to align the display in the best position and
ensure you can use all 8 mounting screws.
2. Install the assembly (from Step 1) into the
vehicle (using factory screws/bolts).
3. Install the dash kit main frame and any factory
panels that would affect the display installation.
Note: If there is a depth issue with the radio
module in the top position, move it to the bottom
location by inverting the mounting bracket
assembly. (FIG. N)
12
FIG. M
Factory Bracket
FIG. N
M5 X 10
#10 X 3/8
Coarse Thread Screw