AEG DC 2 Bedienungsanleitung Seite 42

42 www.aeg-automotive.com
CLEANING, CARE
AND MAINTE-
NANCE
Minimal care will ensure your device
remains functional for years.
•
Carefully wind the cable when storing
the device. This will help prevent
accidental damage to the cable and
the device.
•
Clean the product with a soft, dry
cloth.
•
Store the machine in a clean, dry
place.
Changing the fuse
The car plug of this device has a fuse. It
is triggered by short-circuits or voltage
peaks and will then require replace-
ment.
Attention!
Do not insert higher rated fuses. This
may otherwise damage the electronics.
3
2
1
1. unscrew the retaining ring (1) with
the safety cover (2) from the car
plug (4).
2. Insert a new microfuse (3) of the
same rating (see Technical Data).
3. Screw the retaining ring (1) with the
safety cover (2) back onto the car
plug (4).
Service
Please contact your speciality retailer
if you have any questions about using
or operating the device after reading
these instructions or if for any problems
with your device.
Disposal
The packaging consists of non-conta-
minating materials that you can dispose
of at your local recycling point.
In accordance with European Directive
2012/19/EC for waste electrical and
electronic equipment (WEEE) and
conversion to national law, used
electrical appliances must be collected
separately and taken to a recycling
point. For ways to dispose of old electri-
cal appliances please contact your
community or city administration.
battery packs to a public waste
management or collection site. Properly
4
dispose of damaged or defective
battery packs in compliance with local
regulations.
Illustrations may vary slightly from the
product itself. We reserve the right to
modify the product in accordance with
technical advances. Decoration not
included.
Do not throw electrical appliances
in withdomestic waste!
Do not dispose of waste batteries
with household rubbish. Discharge
used battery packs and return the