AEG DC 2 Bedienungsanleitung Seite 40

40 www.aeg-automotive.com
Setting
LDWS
FCWS
Calibrate LDWS
Lighting
FW version
Calibrating the lane departure war-
ning system
Warning!
Only calibrate the device in a safe envi-
ronment. Never calibrate the device on
public roads or in moving traffic.
1. Press the MENu button to open the
"Settings" menu.
2. use the uP/DOWN button to select
"Calibrate LDWS" and press the OK
button.
3. Press the OK button again to start
the calibration.
To cancel the calibration process,
press the MENu button.
The active setting will be displayed
with a red line. The current calibration
is shown with a green triangle which
changes with the new setting.
4. Press the uP/DOWN button to
move the active setting vertically or
horizontally.
Description / values
Enable or disable lane departure warning system.
On, Off
Enable or disable front collision warning system.
On, Off
see "Calibrating the lane departure warning system"
Set exposure correction.
-2, -1.7, -1.3, -1, -0.7, -0.3, 0, 0.3, 0.7, 1, 1.3, 1.7, 2
Shows the firmware version
5. Press the OK button to confirm the
desired position of the red line.
upper intersection point:
•
Align the vertical line with the middle
of the road.
•
Align the horizontal line with the
horizon.
Left intersection point:
•
Align the vertical line with the left
roadside.
•
Align the horizontal line with the end
of the bonnet.
Right intersection point:
•
Align the vertical line with the right
roadside.
•
Align the horizontal line with the end
of the bonnet.
6. Press the OK button to confirm the
calibration.