AEG DC 2 Bedienungsanleitung Seite 37

•
Do not cover the device during use
and ensure proper ventilation.
Switching the camera on and off
•
The camera automatically switches
on and starts recording when starting
the engine.
•
When the engine is shut off, the
camera saves the current recording
and automatically switches off.
•
The recordings of the front and rear
facing camera are saved separately.
1. To manually switch on the camera,
briefly press the OK button.
2. hold the OK button to switch the
camera off.
Note:
Without power supply, the camera
automatically switches off when the
battery is low.
Formatting the memory card
1. Press the MENu button.
2. use the uP/DOWN button to select
"Form. SD card".
3. Press OK to confirm.
4. use the uP/DOWN button to select
"Yes".
5. Press OK to confirm.
6. The memory card will now be
formatted.
Wait for the process to complete.
Recording video (video mode)
After switching on, the camera auto-
matically switches to video mode and
starts recording.
1. To start recording manually, briefly
press the OK button.
The red camera symbol will appear
and the blue LED will flash.
2. To stop recording, press the OK
button again.
Taking pictures (photo mode)
To take a picture, briefly press the
DOWN button.
The picture will automatically be saved
and can later be viewed in playback
mode.
Viewing recordings (playback mode)
1. use the MODE button to select
playback mode (if necessary).
2. use the uP/DOWN button to select
the desired category:
•
normal recordings
•
protected recordings
•
parked mode recordings
•
photos
Note:
Recordings from the front and rear
facing camera are saved under separate
categories.
3. Press the OK button to confirm your
selection.
4. use the uP/DOWN button to select
the desired recording.
5. Press the OK button. The video will
play or the picture will be shown.
6. To stop playback or close the pic-
ture, press the OK button again.
English 37