AEG DC 2 Bedienungsanleitung Seite 36

36 www.aeg-automotive.com
Attention!
Disconnect the negative cable from
the vehicle's battery before working
on the vehicle's electric circuit! Stored
information, codes and programming
may be lost! To prevent possible
damage, please first consult the vehicle
manufacturer.
9. Now connect the red supply cable of
the camera cable to a 12 V + (posi-
tive) supply of the vehicle.
Warning!
Do not route the cable near where the
airbag deploys.
10. Route the camera cable (19) to
connect to the front facing camera
in the interior/void of the vehicle.
Ensure the cables will not be pin-
ched or tied.
11. Plug the connector (20) of the
camera cable into the connecting
socket (1) on the front facing
camera.
The rear facing camera can be swivelled
in one direction. Swivel the camera into
the desired position.
Installing the front facing camera
Attention!
When installing the device, ensure it will
not obstruct your view. The connecting
cable must not interfere with your
ability to drive and the monitor must
be firmly secured in place. Observe the
applicable laws and safety rules for
automobiles!
1. Screw the thread (21) of the suction
cup mount into the intake (4) of
the camera. Turn the knurled screw
toward the camera to secure the
screw joint.
2. Clean the area of the windscreen
where you wish to attach the suc-
tion cup (23).
3. Press the suction cup against the
windscreen and push the locking
lever (24) toward the suction cup.
4. Open the lock nut (22) and adjust
the camera to the desired viewing
angle. Then tighten the lock nut
again to fix the camera.
5. Plug the uSB connecting cable (25)
into the connecting socket (2).
6. Route the uSB connecting cable so
as not to impair or jeopardise the
safety of the vehicle and occupants.
7. Plus the car plug (25) into a 12 V car
socket.
OPERATION
Warning!
Do not operate the monitor whilst
driving, as this distracts from traffic.
Maintain your focus on driving and
traffic.
Information about use
•
You may have to turn the ignition to
activate the vehicle's 12 V car outlet.
Please refer to the owner's manual
for your vehicle. Contact a specialised
shop if you are unsure.