AEG DC 2 Bedienungsanleitung Seite 35

INSTALLATION
Inserting the memory card
A memory card is required to save
device recordings.
Insert a TF/microSD card (not included)
in the TF/microSD card slot (15).
We recommend formatting the TF/
microSD card directly in the camera
prior to first use (see "Format memory
card").
Installing the rear facing camera
Attention!
Due to differences in technical and
design-related vehicle types, these
instructions for use do not apply to all
vehicle models.
1. Remove the number plate from its
bracket.
2. unscrew and remove the number
plate holder.
3. Now locate an opening / hole to
the interior of the vehicle near
the number plate to feed the plug
of the connecting cable for the
camera into the vehicle's interior.
Remove the interior trim around the
number plate for easier visibility and
installation. If there is no opening on
the vehicle, drill a hole with a 10 mm
(diameter) drill bit in the trim area
around the number plate.
Attention!
be sure there are no electrical wires
or other automotive parts in the area
where you will be drilling which could
be damaged!
4. To protect the borehole in the metal
panel from corrosion the metal
edges should be coated with a
suitable paint coating (e.g. automa-
ker's touchup pen) and allow to dry
adequately.
Attention!
The location of the rear facing camera
must not affect the functionality of
the number plate lamp! If it will affect
the number plate lamp, install the rear
facing camera in a different suitable
location.
5. Feed the plug of the camera
cable (19) into the interior of the
vehicle or the boot lid.
6. Mount the rear facing camera to the
vehicle with suitable fasteners (not
included).
Be sure the cable output at the back of
the camera is always up to maintain the
maximum swivel range.
If desired, you may also use caulk to
seal the opening for the camera cable
from both sides to prevent water from
entering.
7. Attach the mounting plate and the
number plate holder to the vehicle.
8. Attach the number plate.
English 35