ATOMSTACK MAKER R2 Installationshandbuch Seite 8

Use LightBurn
2. Open the Rotary Setup window and set the parameters
2.1 Open the Rotary Setup window: Click "Laser Tools" on the toolbar and then click "Rotary Setup"
Rotary Setup
2.2 Set the correct parameters in the Rotary Setup window: As shown in the figure
Steps:
(1) Select the rotary type: Roller Type
(2) Turn on "Enable Rotary"
(3) Select the "Y Axis" rotary axis
(4) Input the parameters (fixed value) of the rotary equipment
(5) Enter the parameters of your engraved object: The actual measured diameter
Parameters of rotation
or circumference of the engraved object
The parameters of your sculpted odject
6