Philips EP3347/90 Benutzerhandbuch Seite 24

English
22
Problem
The milk does not froth.
Milk is leaking from the
bottom of the LatteGo
milk container.
The machine seems to be
leaking.
Cause
Machines with LatteGo: LatteGo is
incorrectly assembled.
Machines with LatteGo: the milk
container and/or frame of
LatteGo are dirty.
Machines with classic milk frother:
the milk frother is dirty.
The type of milk used is not
suitable for frothing.
The frame and the milk container
are not assembled properly.
The machine uses water to rinse
the internal circuit and brew
group. This water flows through
the internal system directly into
the drip tray. This is normal.
The drip tray is too full and has
overflowed which makes it look
like the machine is leaking.
The water tank is not fully
inserted and air is drawn into the
machine.
The brew group is dirty/clogged.
The machine is not placed on a
horizontal surface.
The water tank is not fully
inserted and air is drawn into the
machine.
Solution
Make sure that the milk container is
properly assembled to the frame of
LatteGo ('click').
Disassemble LatteGo and rinse both parts
under the tap or clean them in the
dishwasher (see 'Cleaning LatteGo after
every use').
Thoroughly clean the milk frother (see
'Cleaning the classic milk frother ').
Different types of milk result in different
amounts of froth and different froth
qualities. We have tested the following
milk types which proved to deliver a good
milk froth result: semi-skimmed or full-fat
cow's milk and lactose-free milk.
First insert the top of the milk container
under the hook at the top of the frame.
Then press the bottom part of the
container. You hear a click when it locks
into place.
Empty the drip tray every day or as soon as
the 'drip tray full' indicator pops up
through the drip tray cover. Tip: Place a
cup under the dispensing spout to collect
rinsing water and reduce the amount of
water in the drip tray.
Empty the drip tray every day or as soon as
the 'drip tray full' indicator pops up
through the drip tray cover.
Make sure the water tank is in the correct
position: remove it and insert it again
pushing it as far as possible.
Rinse the brew group.
Place the machine on a horizontal surface
so that the drip tray does not overflow
and the 'drip tray full' indicator works
properly.
Make sure the water tank is in the correct
position: remove it and insert it again
pushing it as far as possible.