Abus HDCC90002 Anleitung Seite 97

NTP
The Network Time Protocol (NTP) is used for automatic time synchronisation via the
network or Internet.
Activate
Interval (min.)
NTP Server
NPT port
NAT
Network Address Translation (NAT) is used to separate internal and external
networks.
ATTENTION: It is recommended to leave the AutoUPnP function set to "Manual".
(Assignment type).
Activate UPnP
Assignment type
Advanced Settings - SNMP
The Simple Network Management Protocol (SNMP) is used to monitor and control
network elements from a central station. The protocol regulates the communication
between the monitored devices and the monitoring station.
Activate
SNMP version
SNMP Port
Writing Community
Reading Community Enter the "Key" here according to the settings of your SNMP
Trap address
Here you activate the NTP function on the recorder
Here you select the interval for synchronisation
Enter the IP address of the NTP server here.
Enter the port of the NTP server here.
Activate the checkbox to activate the visibility in an IP
network. If this function is activated, port forwarding is
automatically entered in the router for all network ports (if
UPnP is active in the router).
If UPnP is activated, the network ports configured by UPnP (if
ABUS DDNS is active) are transmitted to the ABUS server.
If set to "manual", the network ports can be set manually via
the "Edit" button.
When set to "Auto", the recorder checks for free network ports
on the router and sets the port numbers according to a
random pattern.
Activate checkbox to establish a connection with SNMP
software
Version of the SNMP system
Enter the SNMP port here, normally 161.
Enter the "Key" here according to the settings of your SNMP
software.
software.
Enter the IP address of the SNMP manager here.
97