Sharp RG-F251G(BK) Serviceanleitung Seite 4

RG-F251G
RG-F252E
© DISASSEMBLY
[ Caution on Disassembly
Follow the below-mentioned notes when disassembling the
unit and reassembling it, to keep its safety and excellent
performance:
1. Take cassette tape out of the unit.
2. Take off nylon bands or wire holders where they need
by removed when disassembling the unit. After servicing
the unit, be sure to rearrange the leads where they were (C)x1
before disassembling.
3. Take sufficient care on static electricity of integrated
| circuits and other circuits when servicing.
STEP REMOVAL PROCEDURE FIGURE
1 Bottom Cabinet 4-1
2 =| Front Panel 4-1
3 | Mechanism Block 4-2
Figure 4—2
Figure 4—1
STRINGING OF DIAL CORD
. Hook a thread as shown in Figure 4—3.
2. Turn the shaft fully counterclockwise and fit the left end
of the dial pointer to the boss at the Back Plate as shown
_
in Figure 4—4.
182 +? mm
fe ee a Tuning Control
Shaft (116)
pe
Zs
Za
Ny
1.5 Turns
"O" Point
Figure 4—4
Back Plate (115)
Figure 4—3