Panasonic CQ-RD445LEN Serviceanleitung Seite 6

continued
To reduce interference during
FM stereo broadcasts
Press and hold the MONO/LOC for more than 2 seconds to switch
monaural reception in case much interference is present in an FM stereo
signal or to improve the listening quality of weak FM broadcasts.
LOCAL
ONO
Press and hold MONO/LOC to switch the mode in the following order.
Release your finger at the desired mode. :
MONO OFF MONO ON MONO ON MONO OFF
LOC OFF LOC OFF LOCON ™ LOCON
re he}
Switching from DX to LOC
Normally, searching stops even at a weak wave station. (DX mode)
To stop searching at a strong wave station only, press and hold for more
than 2 seconds MONO/LOC.
During the AM band reception, press and hold for more than 2 seconds
to switch on or off the LOC mode as follows.
LOC OFF <> LOC ON
Preset Station Setting
Up to 20 stations can be preset in the station memory as follows;
Manual Station Preset
@ Press BAND to select a desired band.
@ Use manual or seek tuning to find a station that you want to program
into memory. ;
@ Press and hold one of the station selector buttons 1 through 5 fo
more than 2 seconds until the display blinks. .
Repeat the process to set other stations for the FM1 to AM bands. °
waa — Preset Channel Indicator
Note: You can change the memory setting by repeating the above proce-
dure.
Tuning in a Preset.Station
Press any of the buttons 1 through 5 to tune in the station preset by the
above steps M to @.
Auto Station Preset
Select a band and press and hold AUTO PRESET for more than 2 sec-
onds.
@ The five strongest available stations will be automatically set in memo-
ry on preset buttons 1 through 5.
e Once set, the preset stations are sequentially scanned for 5 seconds.
@ Press the appropriate preset button for the station you want to hear.
N= 1SEPG
N31