Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1. Using the Product as Intended
This locomotive is to be used only with an operating system
designed for it (Märklin AC, Märklin Delta, Märklin Digital
or DCC).
2. Safety Notes
Make sure you read the following safety notes before using
this Märklin product for the first time.
• This toy train set must never be supplied with power from
more than one power pack (max. 22V).
• This toy train set may only be used with a switched mode
power pack designed for toys.
• Use only switched mode power packs and transformers
that are designed for your local power system.
• The 66201 switched mode power pack or the 66471 trans-
former is suitable for this toy.
• The switched mode power pack is not a toy.
• Make sure you inspect the condition of the switched
power pack and its connections to the wall outlet for
damage at regular intervals (depending on how often the
switched power pack is used to play with the train), at
least once a week. This must be done with the switched
power pack unplugged from the wall outlet. If you have
the slightest suspicion that there is damage, the switched
power pack may not be used again until it has been
checked and repaired by the Märklin Repair Department).
• Pay close attention to the safety notes in the
instructions for your operating system.
• The feeder track must be equipped to prevent interference
with radio and television reception, when the model is to
be run in conventional operation. The 74046 interference
suppression set is to be used for this purpose.
• WARNING! Not suitable for children under 3 years. Sharp
edges and points required for operation. Danger of choking
due to detachable small parts that may be swallowed.
Misuse of the switched mode power pack can cause an
electrical shock.
• Do not expose the model to direct sunlight, extreme
changes in temperature, or high humidity.
2.1 Important Notes
• The operating instructions and the packaging are a com-
ponent part of the product and must therefore be kept as
well as transferred along with the product to others.
• Maintenance, servicing, and repairs may only be done by
adults.
3. Contents
1 x Locomotive
1 x Set of instructions for use
1 x Warranty card
4. Functions
• Recognition of the mode of operation: automatic.
• Mfx technology for the Mobile Station / Central Station.
Name set at the factory: 218 424-0
• Address set at the factory: MM 72 / DCC 03
• Setting the locomotive parameters (address, accelerati-
on/braking delay, maximum speed): with the Control Unit,
Mobile Station, Central Station.
7
Werbung
