Sharp SUMOBOX PRO Bedienungsanleitung Seite 12

12
NOTES:
When in Duo Mode, only the Bluetooth source CH3 from the LEFT (primary)
SumoBox will be shared. Input from Mic 1 and Mic 2 on both speakers will
remain local to that speaker.
It is not possible to connect to the RIGHT (secondary) SumoBox via Bluetooth
when Duo Mode is active.
If two speakers have already been paired, Duo Mode / TWS will reconnect
automatically when both speakers are powered on.
Speaker link
SumoBox can be linked to other SumoBoxes via speaker linking. This is
the optimal way to share audio incoming via CH1 and CH2 with another
SumoBox.
You can do this in various ways:
1. One way link:
F on page 3).
(Refer to
Connect one speakers OUT socket to another speakers IN socket.
When in this configuration, the OUT unit will not play any audio
connections from the IN unit.
2. Two way link:
(Refer to G on page 3).
Connect one speakers OUT socket to another speakers IN socket, and
vice-versa.
When in this configuration, the audio on both units is sent to each other.
3. Daisy chain link:
H on page 4).
(Refer to
Connect one speakers OUT socket to another speakers IN socket, then
that speakers OUT socket to another speakers IN socket.
When in this configuration, the audio on the first speaker is sent down
the chain. You can add as many SumoBox as you want.
4. Two way link (small band):
I on page 4).
(Refer to
Using the two way link, you have 6x inputs where the audio on both
units is sent to each other. This is ideal for a small band, for example.
NOTES:
You can daisy chain multiple SumoBox as the speaker link function on
SumoBox is an amplified output. Daisy chaining might not work correctly
using similar products from other manufacturers as these links may not be
amplified.
Sharp Life App
You can download the Sharp Life App onto your smart device.
The app allows full control of the SumoBox and also offers some
additional features.
To pair the app to the SumoBox, do the following:
1. Initial set up
If you're connecting to the app for the first time, but have previously
connected a device to play audio via Bluetooth, you will need to
disconnect your Bluetooth device.
To disconnect the Bluetooth connection, press the Bluetooth / Duo
Mode button once.
2. On your smart device, open the Sharp Life app. Click on "Add Device".
Your device will scan automatically for the SumoBox.
3. Once the SumoBox is found, tap the + symbol to begin the pairing
process.
When pairing is complete, tap the device icon and the SumoBox user
interface will load.
To download the app, use this QR code to go automatically to the
download page or visit: https://www.sharpconsumer.com/sharp-life-app
NOTE:
Only one SumoBox can be connected to the Sharp Life Account at any one
time.
A factory reset will clear the memory and allow a new Sharp Life account to
be connected.
Factory reset
Long press (>10 seconds) the Ducking button to reset the unit to
factory settings. An audio tone will confirm the reset and the panels back
lights will flash once.
Standby mode
You can put SumoBox into standby by long pressing (>3 seconds) the
Bluetooth/Duo Mode button.
To quickly power back on, press the Bluetooth/Duo Mode button once.
NOTE:
SumoBox will automatically go into standby mode when no input signal has
been detected for more than 15 minutes.
Whilst in App mode, standby is disabled.
Corner protectors and grille
SumoBox comes with 8x Corner Protectors and 16x screws. Use the
included hex driver tool to affix them to each corner.
There are 4 types of corner, each with lettering on the inside surfaces:
Corner Type SumoBox Location
FTL/FBR Front Top Left or Front Bottom Right
FTR/FBL
Front Top Right or Front Bottom Left
RBL/RTR
Rear Bottom Left or Rear Top Right
RTL/RBR
Rear Top Left or Rear Bottom Right
You will need to remove the pre-installed feet from the SumoBox to
attach the Corner Protectors.