Cramer 2600186 Bedienungsanleitung Seite 7

To turn left:
1. Depress and hold the drive paddle.
2. Pull the left zero turn trigger to turn the machine to
left.
To turn right:
1. Depress and hold the drive paddle.
2. Pull the right zero turn trigger to turn the machine to
right.
NOTE
For self-propelled drive mode, this machine provides
with 3 forward speeds and 1 reverse.
4.6 START AUGER AND
SELF-PROPELLED DRIVE
SIMULTANEOUSLY
Figure 2
1. Push the ON button.
2. Depress and hold the auger engagement paddle to
start the auger.
3. Depress and hold the drive paddle to start self-
propelled drive.
NOTE
Finish these 3 actions within 5 seconds.
4.7 LOCK SELF-PROPELLED DRIVE
PADDLE AND AUGER
ENGAGEMENT PADDLE WITH
ONE HAND
Figure 2
When you push the self-propelled drive paddle and the
auger engagement paddle at the same time, the auger
engagement paddle will be temporarily locked.
Release the auger engagement paddle (right hand) and
the auger engagement paddle will remain engaged.
This feature allows you to adjust the auger speed, self-
propelling speed, and discharging direction of the snow
while the auger rotates.
To stop the auger, release the self-propelled drive
paddle and both the auger and the self-propel function
will stop.
4.8 MANUALLY MOVE THE MACHINE
Figure 10 - 11
English
When the pushing resistance of the whole machine
becomes large or cannot be pushed, the user needs
to check whether the unilateral wheel can be turned
by hand when it is off the ground. If it can't be rotated
easily, you need to disassemble the chassis bottom
plate and unplug the motor cable. Manual promotion
can be resumed at this time.
1. Unscrew the eight screws.
2. Remove the bottom chassis plate.
3. Unplug the motor cable.
4. Reinstall the bottom plate with eight screws.
5. Manually push the machine to move.
4.9 LED HEADLIGHTS
Figure 2, 12
Turning the headlights on：
• Push the button to turn on the LED light.
Turning the headlights off：
• Push the button to turn off the LED light.
Push button to adjust the light:
• A. Turn on the front lights.
• B. Turn on the rear lights.
• C. Turn on all lights.
• D. Warning light.
4.10 ADJUST THE DISCHARGE CHUTE
Figure 13 - 15
You can adjust the discharge chute 200° to change
snow discharge chute direction.
1. Pull back the chute adjustment handle for a short
distance.
(The lock button will be pulled down to allow the chute
move.)
2. Rotate the chute adjustment handle left to move the
discharge chute to the left. Release the grip handle
to lock the chute in the desired direction.
3. Rotate the chute adjustment handle right to move
the discharge chute to the right. Release the grip
handle to lock the chute in the desired direction.
4.11 ADJUST THE CHUTE DEFLECTOR
Figure 2, 16
You can adjust the chute deflector up and down to
change the throwing distance of the snow.
Turn off the machine before you adjust the chute
deflector.
7
NOTE
WARNING
EN