Difrax C168 Bedienungsanleitung Seite 8

Choose a suitable tip.
1. The narrow tip (8) is recommended for use when the nasal secretion is loose and in a liquid form.
2. The large tip (9) is recommended for use when the nasal secretion is in a thicker, more solid form.
Insert the assembled suction head into the connector, and rotate it clockwise to secure it in the base. Make sure
the head is connected correctly.
Manual cleaning
Disassemble all parts. Clean all head elements in warm water with mild detergent and rinse thoroughly after
each use. Use a cleaning brush for better effects. Silicone elements (fig. 1, parts 8 and 9) can be scalded.
Warning! After each use, be sure to disassemble all head parts for cleaning. The device is not waterproof. Never
immerse the base in liquid. Clean with a cloth.
Automatic cleaning
Assemble the nasal aspirator following the assembly instructions. Remove the plastic cover (6). Then connect
the silicone drain pipe (15). Prepare clean water in a vessel. Place the end of the pipe in a sink. Press the ON/
OFF button (2) to start the cleaning process (fig. 3). To ensure hygiene, clean after each use. Do not clean the
device while it is plugged in!
Use the nasal aspirator in a comfortable position. See fig. 4.
NOTE:
Choose one of three different suction levels by pressing the mode button. Check the suction strength on the
mode indicator: 1 - low, 2 - medium and 3 - high, depending on the needs and nasal secretions.
WARNING!!! Lay your baby on the back or try to hold its head during usage. Don't insert the tip into nostrils too
deep. Never use on ears, mouth, or eyes.
How to remove nasal secretion more efficiently? Press the ON/OFF button to turn the device on. Insert the
suction tip into a nostril. Gently move the tip in small circles to remove nasal secretion more effectively. We rec-
ommend using saline solution to soften dried nasal secretion. Spray the saline solution into the baby's nostrils.
Wait for 3-4 minutes. Then suck the nasal secretion away with the aspirator. Low pressure is formed if air cannot
get into the nostril, so it's easier to suck out the nasal secretion if the suction tip is close to the nasal cavity.
Always track the collection cup and headpiece during use. If there is too much nasal secretion, it may get into
the suction port, which may cause malfunction of the device. If you notice that there is a lot of nasal secretion
in the collection cup or headpiece, turn off the device immediately and clean it. Use a cotton swab to dry the
suction port and remove nasal secretions. If the suction port has sucked a lot of nasal secretions, shake it out
or blow it out with a hairdryer.
Remove the headpiece before cleaning.
Comments
The nasal aspirator generates a vacuum to remove nasal secretion. Frequent nasal congestion and runny nose
caused by infections or allergies can trigger rhinitis. In case of disease or cold, please consult the doctor.
Keep out of the reach of children.
Dispose of following regulations on waste electrical and electronic equipment.
Model: C168
Standard: 2014/35/EU (LVD)
2014/30/EU (EMC)
2011/65/EU (RoHS)
CLEANING
HOW TO USE
SPECIFICATION
External power supply: 5V DC / 1A
Power consumed by the device: 3.7W
Built-in rechargeable battery: 1500mAh
6