Difrax C168 Bedienungsanleitung Seite 7

ELECTRIC NASAL ASPIRATOR MODEL NO. C168
Please read this manual carefully before using the device. Retain for future reference.
1. Make sure that the device and head are well assembled before use.
2. When any abnormality occurs, turn off the device.
3. Read the manual carefully before the first use.
4. Important!
- Keep out of the reach of children when not in use.
- Do not store near heat sources and do not expose to extreme temperature, high humidity, or dust.
- Avoid storing with chemicals or flammable gases.
5. If the device is damaged, immediately contact the manufacturer.
6. Do not change device settings.
7. Maintenance:
- Check the device and all its accessories regularly.
- Avoid long-term use. Check the device before each use.
8. Don't insert the tip into nostrils too deep.
9. Never use on ears, mouth, or eyes.
10. For non-commercial home use only. This nasal aspirator is for removing nasal secretions only. Do not use
this device other than for its intended purposes. The manufacturer is not responsible for product misuse.
11. For charging, use the adapter included.
1. Connector
2. ON/OFF button
3. Mode button
4. Mode indicator
5. Battery indicator
6. Plastic cover
Check the aspirator for any obvious damage and missing parts. If the device is damaged or some parts are
missing, contact the device manufacturer.
• A low battery charge is indicated by the battery indicator (5). If the indicator lights red, connect the device
to the power supply.
• Connect the USB cable included in the set with an original 5V/1A adapter.
• Plug the USB cable into the device port.
• Plug the adapter into a 230V AC outlet. Do not use the device during charging.
• Once the device is fully charged, the battery indicator (5) will light green.
• The device turns off automatically after 2 minutes from the start.
1. Join the tip (8) with the collection cup (7). See fig. 2a.
2. Put the non-return cover (10) on the headpiece (11). See fig. 2b.
3. Tighten by turning it clockwise. See fig. 2c.
4. Insert the suction head (2c) into the connector of the nasal aspirator.
5. Join the head with the base. See fig. 2d.
INSTRUCTIONS FOR USE
NOTE
PARTS OF THE DEVICE, FIG. 1
7. Collection cup
8. Narrow tip
9. Large tip
10. Storage chamber cover
11. Headpiece
BEFORE FIRST USE
ASSEMBLY INSTRUCTIONS, FIG. 2
5
12. USB cable
13. Adaptor
14. Cleaning brush
15. Silicone drain pipe
16. Charging port
EN