neno Perla Bedienungsanleitung Seite 12

03. ELEMENTS
FIG. A
1. Reducer 19mm
2. Reducer 22mm
3. Breast shield 26mm
4. Pumping device
5. Membrane x2
6. Charging cable
7. Milk container cap
8. Milk container
9. Valve x2
10. Connector
04. DISPLAY ICONS
FIG. B
1. Battery status - The battery icon shows the state of charge of the battery.
Connect the device to charge when the battery is close to empty.
2. Power button - Hold the button for 2 seconds to switch the device on or off.
When the device is on, press to pause the breast pump.
3. Mode change button - Press the button to change the mode of the device.
There are 3 modes available (stimulation, deep suction, mixed).
4. Stimulation mode icon.
5. Suction level - Shows the currently selected suction power level.
6. Deep extraction mode icon.
7. Changing the suction level - Press „+" to increase the suction power.
8. Changing the suction level - Press „-" to reduce the suction power.
9. Mixed mode icon.
05. CLEANING AND DISINFECTION
Washing and disinfecting are two different operations. They must be carried out
separately to protect your baby and to ensure that the breast pump works properly.
Washing - washing the surface of the unit and removing dirt.
Disinfection - killing organisms such as bacteria or viruses that may be present on
the surface of the equipment.
Breast shield, membrane, valve, reducers, connector, milk container:
Wash and disinfect before first use.
Wash after each use.
Once a day and before first use - disinfection.
A. WASHING:
- Disassemble all parts of the breast pump (except the pumping device) and wash
in warm soapy water for 5 minutes, then rinse. Do this immediately after using the
12