LEXIBOOK SHUNI Bedienungsanleitung Seite 3

DISCOVER MY INTERACTIVE STYLING HEAD
1. On/High volume
2. On/Low volume
3. Off
4. Try-me mode
5. Music
6. Sounds with the interactive brush
7. Touch sensor on the cheeks for sounds
8. Touch sensor on the nose for sounds
9 & 10. Light effects
11. Notches for accessories
PACKAGING CONTENTS
When opening the product's packaging, please ensure that the following elements are included:
1 x Unicorn interactive styling head
1 x Stickers sheet
1 x Interartive brush
1 x Risk free curling iron
4 x Hair clips
4 x Hair ties
1 x Tiare
1 x Glitter powder
1 x Headband
WARNING: All packaging materials, such as tape, plastic sheets, wire ties and tags are not part of this toy and
should be discarded for your child's safety.
BATTERY REQUIREMENTS
The styling head operates with 3 x 1,5 AA/LR6
Charging the robot :
1. Check that the unit is switched off.
2. Use a screwdriver to loosen the screw on the battery compartment located at the
bottom of the device.
3. Install or replace 3 x AA/LR6 batteries, observing the polarity indicated at the
bottom of the battery compartment, and as per the diagram shown opposite.
4. Close the battery compartment and tighten the screw.
Non-rechargeable batteries are not to be recharged. Rechargeable batteries are to be removed from the
toy before being charged. Rechargeable batteries are only to be charged under adult supervision. Different
types of batteries or new and used batteries are not to be mixed. Only batteries of the same or equivalent
type as recommended are to be used. Batteries are to be inserted with the correct polarity. Exhausted
batteries are to be removed from the toy. The supply terminals are not to be short-circuited. Do not throw
batteries into a fire. Remove the batteries if you are not going to use the toy for a long period of time.
Batteries shall not be exposed to excessive heat such as sunshine, fire or the like.
WARNING: Malfunction or loss of memory may be caused by strong frequency interference or electrostatic
discharge. Should any abnormal function occur, remove the batteries and insert them again.
SHUNI_IM2242_354_V08.indd 2 SHUNI_IM2242_354_V08.indd 2
(Included for demonstration)
15/6/2022 4:38 PM 15/6/2022 4:38 PM