HIKMICRO SP Serie Kurzanleitung Seite 16

point-to-point and non point-to-point
operation as appropriate.
(i)Les dispositifs fonctionnant dans la
bande 5150-5250 MHz sont réservés
uniquement pour une utilisation à
l'intérieur afin de réduire les risques de
brouillage préjudiciable aux systèmes
de satellites mobiles utilisant les
mêmes canaux.
(ii) Le gain d'antenne maximal autorisé
pour les appareils dans les bandes
5250-5350 MHz et 5470-5725 MHz
doivent respecter le pire limiter; et
(iii) Le gain d'antenne maximal
autorisé pour les appareils dans la
bande 5725-5825 MHz doivent
respecter le pire limites spécifiées
pour le point-à-point et l'exploitation
non point à point, le cas échéant.
Users should also be advised that
high-power radars are allocated as
primary users (i.e. priority users) of the
bands 5250-5350 MHz and 5650-5850
MHz and that these radars could cause
interference and/or damage to LE-LAN
devices.
Les utilisateurs de radars de haute
puissance sont désignés utilisateurs
principaux (c.-à-d., qu'ils ont la priorité)
pour les bandes 5250-5350 MHz et
5650-5850 MHz et que ces radars
pourraient causer du brouillage et/ou
des dommages aux dispositifs LAN-EL.
KC
A 급 기기 : 이 기기는 업무용 (A 급 )
전자파적합기기로써 판매자 또는
사용자는 이 점을
주의하시기바라며 , 가정 외의
지역에서 사용하는 것을 목적으로
합니다 .
Safety Instruction
These instructions are intended to
ensure that user can use the product
correctly to avoid danger or property
loss.
Laws and Regulations
● Use of the product must be in strict
compliance with the local electrical
safety regulations.
Transportation
● Keep the device in original or similar
packaging while transporting it.
● Keep all wrappers after unpacking
them for future use. In case of any
failure occurred, you need to return
the device to the factory with the
original wrapper. Transportation
without the original wrapper may
result in damage on the device and
the company shall not take any
responsibilities.
● Do not drop the product or subject it
to physical shock. Keep the device
away from magnetic interference.
Power Supply
● The input voltage should meet the
Limited Power Source (7.2 VDC,
890 mA) according to the
IEC61010-1 standard. Please refer to
technical specifications for detailed
information.
● Make sure the plug is properly
connected to the power socket.
● DO NOT connect multiple devices to
one power adapter, to avoid
over-heating or fire hazards caused
by overload.
Battery
● The built-in battery cannot be
dismantled. Please contact the
manufacture for repair if necessary.
● DO NOT charge other battery types
with the supplied charger. Confirm
there is no flammable material
within 2 m of the charger during
charging.
● For long-term storage of the battery,
make sure it is fully charged every
half year to ensure the battery
quality. Otherwise, damage may
occur.
● DO NOT place the battery near
heating or fire source. Avoid direct
sunlight.
● DO NOT swallow the battery to
avoid chemical burns.
● DO NOT place the battery in the
reach of children.
● When the device is powered off and
the RTC battery is full, the time
settings can be kept for 3 months.
● In the first use, power on the device
and charge the RTC battery with the
lithium battery for more than
2 hours.
● The battery voltage is 7.2 V, and the
battery capacity is 4800 mAh.
● The battery is certified by UL2054.
14