HIKMICRO SP Serie Kurzanleitung Seite 11

No. Description
Micro HDMI
31
Interface
Battery
32
Compartment
33 Lens Release Button
2. Remove the Battery (Page 3 – B)
Steps
1. Turn off the device.
2. Push the battery compartment lock leftwards to unlock the battery
compartment, and then open the battery cover.
3. Push the inner battery lock (in theblack circle) leftwards to release the
battery.
4. Take the battery out of the battery compartment.
Note: If you want to install the battery back, push the battery into the
battery compartment. The battery makes a click when it locks in place.
3. Charge the Battery
After the device starts up, the OSD (on-screen display) shows the battery
status. When the battery is low, charge the device and ensure it works
properly.
For the first charge, charge the device for 2 hours.
3.1 Charge Device via Cable Interface (Page 4 – C - ① )
Steps
1. Put the battery into the battery compartment of the device.
2. Lift the cover of cable interface.
3. Plug in the cable, and connect the power supply to charge the battery.
3.2 Charge Device via Charging Base (Page 4 – C - ② )
Steps:
1. Put one or two batteries in the charging base.
2. Connect the supplied charging base to the power supply. The indicator
in the middle is green if it works properly.
3. The left and right indicators show the charging status of the batteries.
Solid red: charging normally.
Solid green: fully charged.
4. Draw the battery from the charging base, and disconnect charging base
from the power supply.
Function
Connect the device with HDMI cable. A
cable converter (HDMI Type D to HDMI
Type A) is included in the carrying
case.
Install the battery in it.
Unlock the interchangeable lens.
9