Imperial DABMAN i410 BT Bedienungsanleitung Seite 101

6. INSTALLATION
6.2. Preparing the remote control
Remove the battery and insert a new battery of the same type.
There is a risk of explosion if batteries are used improperly! Read the
safety instructions in chapter 2.8 and ensure that the battery polarity is
correct! Then replace the battery compartment.
6.3 Antenna connection
Screw the telescopic aerial supplied to the aerial connection on the back
of the device.
6.4. Power connection
Connect the power supply unit included in the scope of delivery to the
corresponding socket on the back of the device. Now plug the mains
adapter into a 230 V socket. Switch on the device using the mains switch
on the rear panel and switch on the radio using the standby button on
the remote control or on the device. The device starts up.
6.5. Language selection
You can select the menu language using the ▼▲ buttons on the remote
control. Confirm the desired menu language with the OK button on the
remote control.
101 DABMAN i410 BT
E