Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
Swing Marimex 112
Instructions
This product is made and designed to meet the requirements of the Toy Safety Direc-
tive 2009/48/EC.
Safety requirements were checked by an independent laboratory for respective mea-
sures on the toy safety, EN 71-1: 2014(+A1:208); EN 71-2: 2011(+A1:2014);
EN 71-3: 2019; EN 71-8: 2018 and EC/1907/2006/ regulation REACH. All the informa-
tion contained in these instructions are required by respective measures. Follow the
mentioned instructions for keeping the safety of your children.
Assembly instructions
You may assembly this product by yourself. It is necessary to use these assembly
instructions and observe the specified assembly procedure.
Bags and boxes, which the product is packed in, are not designed for children as toys
and do not allow them to play therewith. Do not leave the bags and boxed in nature.
Follow the general instructions for recycling.
Warning!
• Installation must be performed by adult persons.
• During the installation, keep children away – choking hazard in case of small parts.
• Every damaged set part may be replaced only by an original part. Contact servicing
department.
• Not observing these instruction may result in product damage or the danger of
injury.
Before its assembly, make sure that:
1- the place, where you are going to install the set, will be:
a) a horizontal plane
b) At least 2 meters from the set, there are no other objects - fence, trees,
c) This product must not be installed on concrete or any other hard surface.
2- All the packaging is complete. In the event you received part you won't use, keep
them as spare parts. In the event the product is equipped by a slide, we recommend to
set it in a way to avoid sunlight for its longer life span and the danger of burns caused
to the user.
After the assembly:
• Check the difference between the lower part of the set and the ground. Such diffe-
8
string for clothes, electrical wiring, etc., that could cause injury to the user.
Werbung
