MARIMEX 112 Montageanleitung Seite 10

EN ANCHOR THE SWING JET TO THE GROUND (FIGURE NO. 6)
1. Assemble this product on a certain place.
2. Mark the anchoring positions.
3. Check if the product is set according to the figure No. 6 properly or adjust it.
4. Under every anchoring position, make a square of 35x35cm and dig it into the
depth of 35cm.
5. Fill these holes by concrete according to the figure No. 6. Make sure that the
anchors do not exceed the ground plane to avoid tripping.
6. Embed the anchor into the concrete on a marked position (see the point 2). War-
ning: only the drilling part of the anchor should be placed into the concrete.
7. When the concrete is dried, screw the set legs into the anchors.
8. For the use of this product, wait until the concrete gets dry completely.
9. Cover the anchor by soil to avoid tripping.
Thank you for buying this product and we wish you much pleasure when using it!
10
Contact
www.marimex.cz
Custome Centre
tel.: +420 261 222 111
e-mail:
zakaznickecentrum@marimex.cz