HERKULES FSG 2000 LED Bedienungsanleitung Seite 10

Anleitung FSG 2000 LED_SPK7:Anl. TPR 200_1
GB
7.6 45° Lengthwise cut, "jolly cut" (Fig.11)
Loosen the star grip screw (10).
Tilt the guide rail (7) to the left to 45° on the
angle scale (17).
Retighten the star grip screw (10).
Cut as described in 7.4.
7.7 Changing the diamond cutting wheel
(Fig. 12/13)
Pull out the power plug.
Unscrew the four screws (35) and remove the
safety hood (8) for the blade.
Using the wrench (34), loosen the flange nut in
the direction of rotation of the cutting wheel (2).
(Caution: Left-hand screw-thread.) To do so,
place the wrench (31) on the motor shaft and
apply counterpressure.
Remove the outer flange (36) and cutting wheel
(2).
Clean the mounting flange thoroughly before
fitting the new cutting wheel.
Fit the new cutting wheel by following the above
procedures in reverse and then tighten.
Caution: Pay attention to the direction of rotation
of the cutting wheel!
Mount the safety hood (8) for the blade again.
8. Operating the LED light (Fig. 16-17)
Important. Never look directly into the LED light!
8.1 Stationary operation (Fig. 16)
To switch on: Move the ON/OFF switch (46) to the
"1" position.
To switch off: Move the ON/OFF switch (46) to the
"0" position.
Switch on the LED light (45). The work area is now
illuminated. You can additionally adjust the LED light
with the screw (47). To do so, undo the screw (47) by
a few turns. The LED light (45) can now be moved
and adjusted vertically and horizontally on the
adapter (48).
When the LED light is in the desired position,
retighten the screw (47).
8.2 Operation as a torch light/spirit level (Fig. 16)
Remove the screw (47). The LED light can now be
taken off the adapter (48) and used as a torch light.
The base plate (50) of the LED light is magnetic,
enabling it to be secured on suitable surfaces. You
can also use the LED light as a leveling aid using the
integrated spirit levels (49).
10
07.12.2006
8.3 Replacing the battery (Fig. 17)
Unscrew the 4 screws (51) and remove the base
plate (50). Take out the old batteries and replace with
new ones. Then screw the base plate (50) back on.
Remove the LED light
before cleaning the machine
with water.
9. Maintenance
Clean off all dust and soiling from the machine at
regular intervals, preferably with a cloth or a
brush.
Lubricate all moving parts at regular intervals.
Do not use any aggressive cleaning agents to
clean plastic parts.
Clean off any soiling on the trough (3) and
cooling agent pump (13) at regular intervals,
otherwise the diamond cutting wheel (2) may not
be cooled as required.
10. Ordering of replacement parts
When ordering replacement parts, please provide the
following information:
Machine type
Article number of the machine
Identification number of the machine
Replacement part number of the part to be
replaced
For our latest prices and information please go to
www.isc-gmbh.info
14:50 Uhr Seite 10