Jata JVTE4232 Bedienungsanleitung Seite 12

• VERY IMPORTANT: Do not immerse the fan in water or any
other liquid.
• This appliance has been designed for domestic only. Don't
allow children play with the appliance. Keep the fan out of the
reach of children.
• Make sure the appliance is not in direct contact with hot
surfaces or objects.
• Always place it on a flat and stable surface.
• Do not use outdoors or in any room with high humidity or
exposure to water.
• If the power cord or any other component is damaged, it must
be replaced by the manufacturer or by its after-sales service or
similar qualified personnel in order to avoid a danger.
ASSEMBLING INSTRUCTIONS
• Make sure the place where the fan is going to be installed is wide enough, to improve the flow of air through
the room
• To prevent the blades from colliding with any object, it is recommended to leave a minimum distance of 0.60
meters (x) on each side.
• The fan must be installed in such a way that the blades are 2.3 meters from the ground (y).
• The location chosen for its placement must be able to support a minimum of 45 kg in order to support the
weight of the fan.
• Note: the fixing screws (11) (included) are designed to be used with the fan on a wooden ceiling. If the
installation is carried out on a different material (concrete, false ceiling, etc.) it is recommended to use the
appropriate fixing screws for that material (not included). (Fig. 1)
• Place the ceiling support plate (2) in the desired location, ensuring that the ceiling power cables are centered
to make the subsequent connection.
• To mount the blades (1), remove the lower motor screws, each blade has two screws.
• Place the blades (1) keeping in mind that its curve must face up and screw them firmly so that they do not
oscillate when they are in operation. (Fig. 2)
• Then, place the LED light support (8). First, loosen the screws of the round anchor, located at the bottom of
the motor, pass the light cable through the hole and screw it.
• Next, connect the LED lights (9) (Blue-Blue / Black-White)
• The LED lights are attached to the support by magnets so they can be moved for placement. (Fig. 3)
• Two motor support anchors (5) with different lengths are included. Choose the one that best suits your ceiling
height. Unscrew the upper screw of the engine mount anchor, slide the plastic plunger down and remove the
pin. (Fig. 4)
• Remove the retaining clip to extract the pin from the lower end of the engine support anchor (5)
• Insert the roof trim (4) and the engine trim (6).
• Then, pass the upper motor cables inside the motor support anchor (6) to the other edge. (Fig. 5)
• Subsequently, insert the motor mount anchor (5) into the upper motor mount (7) and secure it by inserting the
pin with the retaining clip and tightening the screw. (Fig. 6)
• Place the engine trim (6).
• Insert the upper pin of the motor support anchor (5), keeping the connection cables apart, and raise the
plunger to the end. Next, tighten the screw to leave it well fixed. (Fig. 7)
12