Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3.2 t
ools
Use only clean tools!
3.2.1 c
/
hAnging
fitting the tool
Hold spindle by wrench flats with open end wrench and
screw the tool.
3.3 w
orKing instructions
On failure of the compressed air release the valve lever!
To achieve an optimum grinding result, move grinding
wheel uniformly back and forth with light pressure.
Excessive pressure lessens the working capability of the
machine, as well as the life of the grinding wheel.
4. S
ervIce
4.1 P
reVentiVe mAintenAnce
Without a tool clamped in check no-load speed
periodically and after each maintenance.
Even if the machine still operates perfectly, the
motor should be removed, cleaned and the four slides
checked for wear by a specialist after approx. 300 to 400
operating hours. The lubricant in the gear head (Isoflex
NBU 15) should be replaced (do not wash out).
4.1.1 r
ePlAcement of the exhAust Air hose
Detach the exhaust air hose from the swivel ring, and re-
place it.
4.1.2 r
Detach the hose clamp, and pull the supply hose off the
connection nipple.
/m
aIntenance
ePlAcement of the suPPly hose
Remove the exhaust air hose (see 4.1.1).
13
Werbung
