Fulbat MF Bedienungsanleitung Seite 7

5 PULLING OUT THE CONTAINER
Be certain that all the electrolyte has flowed out. Tap the bottom in the same way as step 4
if there is any electrolyte left in the container.
Now pull the container gently out of the battery.
6 SEALING THE BATTERY
Fit the strip cap plug tightly into the filler ports.
Make sure the strip is at the same level as
the top of the battery.
The fill-up is now complete.
Never remove the caps, no add any
water or electrolyte.
IMPORTANT INFORMATIONS
(1) This battery is a fully charged and sealed before first use, integrating a venting valve.
It contains non-floating electrolyte and any gas produced during use is fully absorbed within
the battery, ensuring that this battery is totally Maintenance Free.
(2) As this battery was activated before installation, it is essential that the battery stands
upright during minimum 60 minutes before installation on the vehicle.
This allows the electrolyte to permeate into internal materials.
(3) Under no circumstances should the Sealing Plug be removed.
(4) The Venting Valve Opening must not be obstructed.
Strip Cap Plug
(Battery plugs)
Press down
horizontally on the
Caps with both
hands
7