Fulbat MF Bedienungsanleitung Seite 6

2 PREPARING THE ELECTROLYTE
Take the electrolyte container out of
the vinyl bag. Detach the strip cap
plug from the container, which will
be used as the battery plugs later.
Note : Do not peel or pierce the
sealed areas.
3 PROCEDURE FOR FILLING BATTERY WITH ACID
Place the electrolyte container upside down with
the 6 sealed areas in line with the 6 filler ports
of the battery.
Push the container down strongly enough to
break the seals.
Air bubbles should come up from ports.
Note : Do not tilt the container as the electrolyte
flow may be interrupted.
4 CHECKING THE ELECTROLYTE FLOW
Make sure air bubbles are coming up as stated in slep 3 above.
Leave the container in this state for 20 minutes or longer.
Note : If there is no air bubbles coming up from
the filler ports, tap the bottom of the container
two or three times. Never remove the container
from the battery.
Never cut the joints with nippers or the like.
6
Stripe Cap
Plug
(used as
battery
plugs)
Air bubbles
Needle