Cardin TXQ449100 Bedienungsanleitung Seite 14

GSM Antenna
The antenna for the GSM card, which is a specific card supplied along with the product, must always be
installed. It should be screwed onto to the dedicated connector on the upper part of the box (see fig.2).
Fastening the antenna to the box by hand, without using any sort of tool, by aligning the antenna with
the base of the terminal and then gently screwing it into place until it is fastened firmly into position.
Transmitters
The transmitter is pre-coded and is fitted with an integrated circuit which is programmed in the factory
with a unique identification number.
All the code parameters are contained in this integrated circuit (external memory modules are not
required) thus making code management more reliable and the system more secure.
The transmitter has an automatic shut down mechanism which cuts in after at least 20 seconds of
continuous use (this limits battery consumption).
Key block function
• A key block function has been added to protect the appliance from accidental activation;
- to activate the function press and hold down "MR" for 8 seconds until the red
led starts flashing, at this point to activate a command you will need to press
the required key three times consecutively;
- to reset the function to standard operation standard press and hold down "MR"
for 8 seconds until the red led starts flashing.
Receiver
Warning! The receivers must only be powered by a safety power pack. The use of non safety power
packs could provoke damage to the system.
Outdoor receiver with LCD display IP55 (fig. 1)
- The outdoor receiver (printed circuit CS1420AB) is fitted with an 13-way terminal board and has the
following electrical connections:
12V ac/dc between binding posts 2-3 and 24V ac/dc between binding posts 1-3
For the installation of the outdoor receiver see the separate instructions for mounting the box
ZVL105.02 supplied with the product.
Interchangeable channel modules
In the receivers the channel functions are printed on the circuit board. Only type MCC4491R0 relays
can be used.
Set the at rest function mode of the relay by inserting
the jumpers J1-J2-J3-J4 (see det. 1):
- Position "P1" = N.O. normally open
- Position "P2" = N.C. normally closed
P1
P2
J1-J2-J3-J4
14
DET. 1
CH A
J1