Werbung
Verfügbare Sprachen
Verfügbare Sprachen
WARNING!! Before proceeding with the disassembly work, a pressure relief
is STRICTLY REQUIRED!
According to chapter 7 Set outlet pressure, minimise the pressure completely (-).
According to Fig. 7.2, turn the hexagonal pin spanner anticlockwise as far as it will go.
/
Fig. 9.6: Turn the screw cap [a] in the direction
of the arrow using a pair of valve pliers and
loosen it from the housing
During assembly, make sure that a
tightening torque in the range of
30 to 35 Nm is maintained.
/
Fig. 9.7: Remove adjusting screw unit [b] and
spring [c]
/
place a slotted screwdriver in the notch of the
spindle [d]
/
carefully lift or lever the unit upwards
/
Fig. 9.8: Remove cartridge [e] with the slide ring [f]
/
clean the cartridge [e] under clear, cold water,
replace if necessary ( see chapter 12 Spare parts)
/
mount the CLEAR PRO RD domestic water
unit in reverse order and screw it to the flange
according to chapter 6.2
/
ATTENTION - DON'T FORGET:
After complete assembly, follow the instructions
in chapter 7, Setting the output pressure
[a]
[b]
[c]
[d]
[e]
[f]
21
Fig. 9.6
Fig. 9.7
Fig. 9.8
Werbung
