HERKULES UFZS 1800 Bedienungsanleitung Seite 22

Anleitung UFZS 1800 SPK 7:Anleitung UFZS 1800 SPK 7
GB
9.1.3. Cutting extremely narrow workpieces (Fig.
21)
Be sure to use a push block when making
longitudinal cuts in very narrow workpieces with
a width of 30 mm and less.
The low guide face of the parallel stop is best
used in this case.
There is no push block supplied with the
saw! (Available from your specialist dealer)
Replace the push block without delay when it
becomes worn.
9.1.4. Making bevel cuts (Fig. 17/23)
Bevel cuts must always be used using the parallel
stop (7).
Set the blade (4) to the desired angle. (See 8.5.)
Set the parallel stop (7) in accordance with the
workpiece width and height (see 8.3.1)
Carry out the cut in accordance with the
workpiece width (see 9.1.1., 9.1.2 and 9.1.3.)
9.1.5. Making cross cuts (Fig. 18/24)
Cross cuts are made with the help of the drag
function.
Set the saw blade to the desired angle (Section
8.5).
Use the universal stop as explained in Section
8.4.
Hold the workpiece firmly with one hand and
press it against the stop rail.
With the other hand slowly pull the saw blade on
the drag device (8) forwards through the
workpiece.
When you have finished the cut, do not allow the
saw unit to jump back into starting position on its
own but guide it back slowly by hand.
Switch off the saw again.
Do not remove the offcut until the blade has
stopped rotating.
10. Maintenance
Important! Pull out the power plug first.
Remove dust and dirt regularly from the
machine. Cleaning is best carried out with a fine
brush or a cloth.
Never use caustic agents to clean plastic parts.
Keep the saw unit drag device clean and
lubricate it in regular intervals.
11. Ordering replacement parts
Please provide the following information on all orders
for replacement parts:
Model/type of device
22
23.05.2007
Article number of the device
ID number of device
Number of the required replacement part
For our latest prices and information please go to
www.isc-gmbh.info
11:45 Uhr Seite 22