VOLTCRAFT VC-JS-800A-WP Bedienungsanleitung Seite 6

11.2 Protection mode
Status indicator Status
Red steady/red flashing Connection error. Please check all contacts.
■
Red on/alarm sound on Reversed polarity: check if the clamps are connected the
wrong way around.
■
Short-circuit: Both cables are clamped together or clamped to
the same piece of conductive metal.
■
Red steady on Reverse charging protection is triggered. Voltage of the con-
nected battery is >12.6 V.
■
The jump starter is not needed as the vehicle battery is
enough to start the vehicle.
Red flashing quickly Over temperature: Clamp >65 (±5) ºC. Remove the clips until the
starter status indicator returns to normal (alternating red/green
flashing).
Green flashing slowly Quick start battery charge is too low, recharge it.
12 Cleaning and care
Important:
– Do not use aggressive cleaning agents, rubbing alcohol or other chemical solutions.
They damage the housing and can cause the product to malfunction.
– Do not immerse the product in water.
1. Disconnect the product from the power supply.
2. Clean the product with a dry, fibre-free cloth.
13 Disposal
This symbol must appear on any electrical and electronic equipment placed on
the EU market. This symbol indicates that this device should not be disposed of
as unsorted municipal waste at the end of its service life.
Owners of WEEE (Waste from Electrical and Electronic Equipment) shall dispose
of it separately from unsorted municipal waste. Spent batteries and accumulators,
which are not enclosed by the WEEE, as well as lamps that can be removed from
the WEEE in a non-destructive manner, must be removed by end users from the
WEEE in a non-destructive manner before it is handed over to a collection point.
Distributors of electrical and electronic equipment are legally obliged to provide free take-
back of waste. Conrad provides the following return options free of charge (more details on
our website):
■
in our Conrad offices
■
at the Conrad collection points
■
at the collection points of public waste management authorities or the collection points
set up by manufacturers or distributors within the meaning of the ElektroG
End users are responsible for deleting personal data from the WEEE to be disposed of.
It should be noted that different obligations about the return or recycling of WEEE may apply
in countries outside of Germany.
14 Technical data
14.1 General
Charging input (Micro-USB) ........... 5 V/DС 2.0 A
Charging input (USB-C®)............... 5 V/DC 2.0 A
Rechargeable battery ..................... 14.8 V 37 Wh, Li-ion (non-removeable),
LED light modes ............................. Constant ON → SOS → flashing → OFF
Ingress protection........................... IP68
Protection mechanisms .................. Over temperature:
Operating conditions....................... Sockets cover open: -20 to +60 °C, 20 – 85 % RH
6
recharge time 6 hrs
recharge time 6 hrs
10000 mAh (4x type 606080)
- discharging: 60 °C ±5 °C
- recharging: 60 °C ±5 °C
Low temperature:
- discharging: -20 °C ±5 °C
- recharging: -20 °C ±5 °C
Overvoltage (USB inputs): max. 6 V
Overcharge: 16.6 V
Over discharge:
- software protection: ≤13 V ±0.3 V 12.5 V - 13 V
- hardware protection: 10.8 V - 11 V
Overcurrent: 3.4 - 3.7 A
(non-condensing)
Sockets cover closed: -20 to +60 °C
Storage conditions.......................... Sockets cover open:
Dimensions (L x W x H).................. 168 x 92 x 38 mm
Weight ............................................ 520 g
14.2 Power bank
Output 1 (USB-A) ........................... 5 V/DC 3 A, 9 V/DC 2 A, 12 V/DC 1.5 A (max. 18 W)
Output 2 (USB-A) ........................... 5 V/DC 3 A, 9 V/DC 2 A, 12 V/DC 1.5 A (max. 18 W)
14.3 Jump starter
Vehicle on-board system................ 12 V/DC
Start current (peak value)............... 400 A (800 A)
Jump starts..................................... approx. 15 (affected by factors such as ambient
Suitable engine types ..................... Petrol (displacement ≤6.0 L), Diesel (displacement
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method (e.g. photocopying, microfilming or the capture in
electronic data processing systems) requires prior written approval from the editor. Reprinting, also in part, is prohibited.
This publication reflects the technical status at the time of printing.
Copyright by Conrad Electronic SE.
*2812940_V2_0823_dh_mh_en 9007200149572235-2 I2/O2 en
0 to +45 °C, 20 – 85 % RH (non-condensing)
Sockets cover closed: 0 to +45 °C
temperature, size, and mechanical condition of the
engine)
≤4.0 L)