S-idee 1609 Benutzerhandbuch Seite 25

Problem
1.The model is of low
battery.
2.The engine or the motor
is damaged.
3.The motor is damaged.
Model fails
to move
4.The electronic speed
regulator is damaged.
5.The wire is damaged.
6.The connector is
damaged.
7.The power connector is
loose.
1.Whether the model or the
engine is of low battery.
2.The receiver is
damaged.
3.There lacks torsion.
4.The rotating member is
not lubricated properly.
5.The steering part is
Model out
damaged.
of control
6.Radio signals at another
receiving frequency
interfere too much with
nearby electronics.
7.The rotating member is
not assembled properly
or is worn.
8.It's beyond the remote
control range.
The charging operation can be completed by connecting the mobile phone charging configuration plug
(standard 5V, 2a), so as to shorten the charging time.
Reminder
WARNING
-Do not use a non factory rechargeable battery to avoid damage to the performance of the model car.
Do not leave unattended when charging.
-Children can charge under the guidance and supervision of adults. Do not use batteries with liquid leakage or
damaged packaging.
-Please fully charge the battery pack before each use.
-This product is not a toy, but a full-scale model car. Children under aged 14 must not operate this producf
unless they are closely supervised by adults.
Solutions to problems
Cause
1.Please remove the old batteries to charge, and put in
fully-charged batteries or no batteries.
2.Please replace the motor as soon as possible.
3.Please replace the engine if the transmission box produces
abnormal noises or gets heated soon when the model runs
at a low speed.
4.Please consult the manufacturer whether it can be recovered.
If not, get a new one.
5.Please reconnect the damaged part and insulate it.
6.Please check whether the power cord of the motor is
disconnected. If yes, re-weld it.
7.Please check whether the contact between connectors of
each part is loose. If yes, please re-plug and fix them.
1.Please charge the model batteries, or put in fully-charged
batteries, or replace them with new engine batteries.
2.Please consult the manufacturer whether it can be recovered.
If not, get a new one.
3.Please apply lubricant to the moving members.
4.Please check whether the steering gear is out of order, and
replace it with a new one when necessary.
5.The swing arm on the steering gear is damaged. Please
confirm whether to replace it with a new one.
6.Try to operate your model at a different location that avoids
electromagnetic interference.
7.Please troubleshoot carefully the part that fails, and check
and re-assemble it. If the gear or any other accessory is badly
worn, please replace it with a new one. Disassembly and
assembly may refer to the proper instructions in the manual.
8.Maintain the remote control of the model within the effective
range.
Processing Method
6