Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1. Remove the battery lid.
Battery lid
3. Replace the lid as shown.
- Use the batteries of same brand
- Do not mix old and new batteries in use.
- Remove the batteries from the transmitter when not
in use. Do not use leaky batteries.
5
7
1. Power Switch(On/Off):Slide it to switch on or off power.
2. Steering Wheel:Proportionally operates the car's right and left steering control.
3. Throttle Trigger:Pull to accelerate,release to slow down,and push it to brake. Center it and then push it a
second time to reverse.
4. Power LED:It flashes rapidly during binding.After binding,it stops flashing and stays on solid.Please
charge the transmitter's batteries in case the LED goes slow flashes.
5. Steering Trim:It is used to make the vehicle drive in straight line.Turning the steering trim knob to adjust.
6. Steering angle rudder amount limit: when turning the steering wheel, use "steering angle rudder amount
limit" to adjust the tire rotation angle.
7. Steering Reverse Switch:It allows you to electronically switch the direction of the steering servo travel.For
instance,if you move the steering wheel to the right and your vehicle turns left,flip this switch to make it
turn right.
8. Speed three gear switch: speed is divided into fast speed, medium speed and slow speed. (beginners are
recommended to use slow familiar operation)
9. Angel eye lamp mode switching:
1) The display states of the headlights are: normally on, fast flashing, slow flashing and off.
2) The "CH3" key controls the display of the headlights. Each time the "CH3" key is pressed, a state is
switched.
Assembly of the transmitter battery
2. Load 3 AA-size alkaline batteries as shown in the illustration.
Caution: install batteries with correct polarity.
3x"AA"Size Batteries for
transmitter(Not Included)
Transmitter function introduce
4
6
1
8
9
2
1.5V AA
1.5V AA
1.5V AA
1.5V AA
3
2
Werbung
