Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Fault/malfunction
Possible cause
Device heats up,
Insufficient air circulation;
makes a lot of
function only available
noise and dehu-
when housing is closed
midifies poorly
Water escaping
Leak in condensate sys-
from device
tem
Red indicator lit
Pump runs dry
Table 1: Troubleshooting table
11 Repair
During the warranty period, all repairs
must be performed by persons au-
thorised by the manufacturer.
After the warranty period has
elapsed, certain repair can be carried
out by the device owner, provided he
or she has the necessary skills.
DANTHERM shall not be liable for
damage caused by such repairs.
If you have any questions about re-
pairs, contact DANTHERM Customer
Service or your dealer.
12 Decommissioning,
storage and disposal
Decommissioning
1. Pump out the condensate.
2. Switch off the device at the device
switch and disconnect the power
plug.
3. Clean the device (see Mainte-
nance and care).
4. Disconnect all incoming and out-
going lines (discharge and power
supply lines).
28
Remedy
Ensure that the air can circu-
late freely; clean evaporator
and filter
Run condensate pump test
with water and locate leak
Check condensate pump
and drain hose for
dirt/blockage
5. Package the device so that it is
protected against moisture and
dust.
Storage
CAUTION! Risk of injury from de-
vice toppling over
Do not stack more than two devic-
es one on top of the other.
Secure devices against toppling
over.
Procedure
Store the device at a temperature
between 5 °C and +40 °C.
Disposal
CAUTION! Risk of damage to the
environment from hazardous sub-
stances
Dismantle the device and recycle
or dispose of the materials accord-
ing to the applicable statutory reg-
ulations.
For the disposal of auxiliary mate-
rials and consumables, observe
the information in the safety data
Werbung
