Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2.3 Placement
Before using the freezer,
remove all packaging
materials including bottom
cushions and foam pads
and tapes inside the freezer,
tear off the protective film
on the door and the freezer
body.
Keep away from heat and
avoid direct sunlight. Do not
place the freezer in moist or
watery places to prevent rust
or reduction of insulating
effect.
2.4 Changing the Light
Any replacement or maintenance of the LED lamps is intended to be made by the manufacturer,
its service agent or similar qualified person.
Above is only for reference. The actual configuration will depend on the physical
product or statement by the distributor
2.5 Start to use
Above is only for reference. The actual configuration will depend on the physical
product or statement by the distributor
2.6 Energy saving tips
The appliance should be located in the coolest area of the room, away from heat
producing appliances or heating ducts, and out of the direct sunlight.
Let hot foods cool to room temperature before placing in the appliance. Overloading
the appliance forces the compressor to run longer. Foods that freeze too slowly may
lose quality, or spoil.
Be sure to wrap foods properly, and wipe containers dry before placing them in the
appliance. This cuts down on frost build-up inside the appliance.
Appliance storage bin should not be lined with aluminum foil, wax paper, or paper
toweling. Liners interfere with cold air circulation, making the appliance less efficient.
Organize and label food to reduce door openings and extended searches. Remove as
many items as needed at one time, and close the door as soon as possible.
(optional)
Use a tool (flat screwd
river or cone), insert it
into the gap at the
arrow position in the
picture and gently pry
it open to the outside
so as to open the flap.
After transportation, please let the freezer stay for more than 2 hours
before turning on the power, otherwise it will lead to a decrease in cooling
capacity or a damage to the freezer.
The freezer shall run 2 to 3 hours before loading fresh or frozen
foods; the freezer shall run for more than 4 hours in summer in
advance considering that the ambient temperature is high.
Please pull out the plug in case of power failure or cleaning. Do not connect
the freezer to power supply within five minutes to prevent damages to the
compressor due to successive starts.
The freezer should be placed
in a well-ventilated indoor
place; the ground shall be flat,
and sturdy .
The top space of the freezer
shall be greater than 70cm,
and the distances from both
sides and backside shall be
more than 20cm to facilitate
heat dissipation.
Werbung
