GreenWorks EAC401 Bedienungshandbuch Seite 5

DANGER
Do not touch the cap of the gear box after operating
the machine, the high temperature may cause the
injury.
8 STOP THE MACHINE
1. Release the trigger to stop the machine.
9 OPERATION TIPS
Figure 5
Before drilling a hole, always look to see what position
the forward/reverse switch is in.
• Push the forward/reverse switch to "F" for forward.
The machine will rotate clockwise and drill down into
the ground. Shift your body weight above the bit to
help it drill.
• Push the forward/reverse switch to "R" for reverse.
The machine will rotate counterclockwise and
attempt to rotate out of the ground. Pull up on the
handles when drilling into the ground, this will allow
the bit to go into the ground and out of the ground
easier. The reverse function can also be used to
help the bit unbind from a root or other obstruction.
• When drilling a deeper hole, clear dirt/ material from
the auger bit occasionally by pulling the unit up 1
m after drilling down every 1.5 m. This will make
the auger easier to remove once the hole has been
completely drilled.
• In thick clay or rocky soils the hole may need to
be drilled more slowly and the earth removed more
often.
• If using in very cold conditions, the battery may
need to be warmed up for the auger to work. This
can be done by placing the battery in a warmer
area (indoors, in a coat pocket, etc.) for a couple of
minutes.
WARNING
Hold the machine firmly with two hands at the same
time and do not loosen your grip before the machine
stops. Operate the machine in pairs if necessary.
10 STORE THE MACHINE
• Clean the machine before storage.
• Make sure that the motor is not hot when you store
the machine.
• Make sure that the machine does not have loose
or damaged parts. If it is necessary, do these steps/
instructions:
• Replace the damaged parts.
• Tighten the bolts.
• Speak to a person of an approved service
center.
English (Original Instructions)
• Store the machine in a dry area.
• Make sure that children can't reach the machine.
11 TROUBLESHOOTING
Problem Possible cause
The battery pack
The motor does
is not installed
not start when
tightly.
you pull the trig-
ger.
The battery pack
is out of power.
The machine
The machine
smokes during
has damage.
operation.
The machine
has damage.
The motor is on,
the bit do not
move.
The bit is
blocked.
The parts are
loose.
There is too
much noise
and/or vibration
during operation.
The parts have
damage.
12 TECHNICAL DATA
Depending on the model purchased, packaging will con-
tain different accessories and parts.
Voltage
No load speed
Bit
5
Solution
Make sure that
you tighlty install
the battery pack
in the machine.
Charge the bat-
tery pack.
1. Immediately
stop the ma-
chine.
2. Remove the
battery pack.
3. Contact the
service cen-
ter.
Do not use the
machine and
contact the serv-
ice center.
Remove battery
pack then clear
blockage from
the bit.
1. Stop the ma-
chine.
2. Remove the
battery.
3. Inspect for
damage.
4. Check and
tighten loose
parts.
Do not use the
machine and
contact the serv-
ice center.
60 V
-1
Forward: 210 min
-1
Reverse: 50 min
Diameter: 200 mm
Length: 890 mm
EN