JK-Products Ergoline PRESTIGE 990-S DYNAMIC POWER Montageanweisung Seite 107

Assembly
09/2012
– Align the acrylic glass panel lock.
NOTE:
Before the screws are fully tightened, lower the acrylic
glass panel and check to make sure that the magnets are
in the correct position above one another.
– Fully tighten the screws.
– Close the acrylic glass panel.
– Remove fingerprints and other soiling carefully.
Tool: No. 2 Philips screwdriver or battery-powered screwdriver with PHZ-bit 2
Set the height of the magnets
If the magnets are not in contact, the height can be adjusted. Adjustment at
the head and foot is identical and is described in the following steps.
– Lift up the acrylic glass panel.
– To adjust the height, rotate the magnets.
– Close the acrylic glass panel.
– Remove fingerprints and other soiling carefully.
Installation Instructions 49/54