Klipsch PSM-450-T Bedienungsanleitung Seite 3

Bypass Position: 8 ohm Nominal
PSM-525-T (Transformer Power Rating: 30W)
70V: 30W, 15W, 7.5W, 3.7W
100V: 30W, 15W, 7.5W
Bypass Position: 8 ohm Nominal
PSM-650-T (Transformer Power Rating: 60W)
70V: 60W, 30W, 15W, 7.5W
100V: 60W, 30W, 15W
Bypass Position: 8 ohm Nominal
PSM-800-T (Transformer Power Rating: 100W)
70V: 100W, 50W, 25W, 12.5W
100V: 100W, 50W, 25W
Bypass Position: 4 ohm Nominal
PSM-800-SW-T (Transformer Power Rating: 150W)
70V: 70W, 35W
100V: 150W, 70W
When making any type of speaker wire connection, be sure to observe
proper polarity. Most speaker wire and connectors are color-coded.
Typically, red is positive (+) and black is negative (–), or ground. It
does not matter which wire conductor is connected to the positive or
negative connection of your equipment as long as it is consistent.
TYPES OF CONNECTORS
Your speaker is equipped with detachable screw euro block connectors
for inputs and outputs. The speaker features a rubber grommet that
can be used to thread the speaker wires through. Also included is
a conduit connector which can be installed by removing the rubber
grommet.Make sure that there is no metal-to-metal contact between
the two wires. Failure to observe this precaution at either end of
the connection can result in amplifier malfunction or damage.
PAINTING
The grille and cabinet of your speakers may be painted. For
best results, lightly sand all surfaces to be painted (cabinet and
grille) with 300-400 grit sandpaper. Wash these surfaces with
a moistened cloth dipped into a mild detergent to remove any
fingerprints or grease. Allow speaker to dry before painting.
Care must be taken to mask off the front of the speaker to protect the
tweeter, woofer and front panel from overspray. This will maintain the
existing uniform dark color behind the grille and protect the woofer
and tweeter from being damaged by the paint. Affix masking tape to
the inboard wall of the grille groove and attach plastic or newspaper
to the tape to cover the entire front panel of the speaker. Also before
painting, mask the connector pins where the euro block connectors
are inserted on the rear of the cabinet to preserve their conductivity.
Remove the grill set screws, grille and speaker terminal cover
before painting. For best results, use several light coats of
paint instead of one heavy coat. This will help prevent the
perforations in the grille from becoming clogged with paint.
Figure 1
A
PRODUCT REGISTRATION
Register your product online at www.klipsch.com/register
• Klipsch will keep you up-to-date on new products and promotions
• Your personal information will never be resold
• This registration information is not used for warranty purposes.
Please retain your receipt for warranty claims.
Figure 2
B