Velleman K6712 Gebrauchsanweisung Seite 23

Receiver set for on/off output:
- the same as with the local push button
Receiver set for pulse output:
- the same as with the local push button
2) CLEAR key:
- Everything off
3) Fixing a memory:
Bring the lights into a certain dim or off state.
Press the keys STORE and MEM1 or MEM2 simultaneously.
The receiver having accepted the memory confirms this by
flashing the light(s) for a while. This may be handy when you have
several receivers in the same room.
4) Calling a memory:
To call memory 1, press CALL1
To call memory 2, press CALL2
5) Making the memory of (a) given receiver(s) insensitive:
When using several receivers, it sometimes may be usefull when
some of the receivers react to memory 1 only and others to
memory 2 only. This can be achieved by first pressing CLEAR and
then preserving this state in memory 1 or 2 of the respective
receivers (pay attention to the flashing of the light(s) indicating that
the new setting has been accepted)
Example: You have four receivers and you have selected four
different channels for operating the receivers separately.
However you would like receivers 1 and 3 to react to memory 1
and NOT to memory 2, and receivers 2 and 4 to react to memory 2
and NOT to memory 1.
Proceed as follows:
- First switch all outputs off (CLEAR key)
- Switch outputs 1 and 3 on (or a given dim setting) and preserve
this state in memory 1 (MEM1). Pay attention to that ALL FOUR
receivers have preserved this state (flashing of the light). While
preserving the memories you must possibly point to the different
receivers.
- Set all outputs back off (CLEAR key)
H6712-ED1-23