Weller WSR 200 Originalbetriebsanleitung Seite 107

EN
ENGLISH
Care and maintenance
WARNING
Before doing any work on the machine, pull the plug out
of the socket.
Clean the operator panel, if dirty, using a suitable cleaning
cloth.
Seal ports which are not in use with covering caps.
Check all connected cables and hoses on a regular basis. If
power tools are damaged, they must be immediately
removed from use.
WARNING Risk of burns
Only replace solder tips when cold
•
Replace and clean suction nozzles only when hot and using
•
the suitable tool
Only replace hot air nozzles using the suitable tool
•
Only clean or replace solder collection tubes when cold
•
Filter change
Regularly check the main filter for vacuum, and replace it
if necessary.
Contaminated filters must be treated as special waste.
Dispose of replaced equipment parts, filters or old devices
in accordance with the rules and regulations applicable in
your country. Wear suitable protective gear.
Warning!
Working without a filter can result in irreparable damage to the
vacuum unit.
Check before starting soldering whether a main filter is
inserted.
Repairs must always be referred to a Weller-trained
specialist.
Use original replacement parts only.
Warranty
Claims by the buyer for physical defects are time-barred
after a period of one year from delivery to the buyer. This
does not apply to claims by the buyer for indemnification in
accordance with §§ 478, 479 BGB (German Federal Law
Gazette).
We shall only be liable for claims arising from a warranty
furnished by us if the quality or durability warranty has been
furnished by use in writing and using the term „Warranty".
The warranty shall be void if damage is due to improper use
and if the device has been tampered with by unauthorized
persons.
For more information please visit
www.weller-tools.com.
12
Symbols
Caution!
Warning! Risk of burns!
Read the operating instructions!
Before performing work of any kind on the unit,
always disconnect the power plug from the
socket.
ESD-compatible design and ESD-compatible
workstation
Equipotential bonding
Soldering
Desoldering
Hot air
CE mark of conformity
British Conformity Mark
Fuse
Safety transformer
Disposal
Waste light sources have to be removed from
equipment. Check with your local authority or
retailer for recycling advice and collection point.
According to local regulations retailers may
have an obligation to take back waste electrical
and electronic equipment free of charge. Your
contribution to re-use and recycling of waste
electrical and electronic equipment helps to
reduce the demand of raw materials. Waste
electrical and electronic equipment contain valu-
able, recyclable materials, which can adversely
impact the environment and the human health,
if not disposed of in an environmentally compa-
tible manner. Delete personal data from waste
equipment, if any.